Showing 70 items
matching donor's badge
-
Melbourne Tram Museum
Photograph, two tramway cable tram employees, in full uniform, c1920
Digital image of two tramway cable tram employees, in full uniform - both gripmen? No bell punch safety pins in use. Shows the style of the uniform - cWW1. Note the Masonic badge on the person sitting. The donor advises that Edwin is standing - see notes.trams, tramways, mto co, cable trams, personnel, employees, gripmen, masons -
Melbourne Tram Museum
Ephemera - Point Ormond Timetable, Last Tram record, 22-10-1960
The MMTB Timetable details the trips from Elsternwick or Point Ormond for each day of the week. The sheet records the time of the last tram, 1036pm, driver G Loft No. 2480, and the tram as X2 677 on 22-10-1960. The donor advised that the MMTB following the practice adopted for the Bourke St changeover in 1940, the MMTB chose to pull the tram service before the last advertised trip for the day. Those present to ride the last started early and rode up and down for quite a few runs, then, on one arrival at Elsternwick Station, the Inspector (known as grasshoppers or Braids) on board instructed the driver to keep going and we rode through to GH Depot without paying another fare. They noted a half-cab bus, destination 'Clifton Hill', lurking ready to take up the running. The donor reported (and as you will see from the endorsements on the timetable) “I circled the time of the last run and got the signature and badge number of the driver. The rubber-stamp impressions were also applied to souvenir tickets (3d).” Yields information about the Point Ormond Service prior to its closure and records details of the last tram service.Foolscap Gestetner duplicated sheet, dated 29/1/1960Marked to show the last tram on 22-10-1960, time, tramcar and driver's name and number.tramways, timetables, tram 677, point ormond, closure, last tram -
Melbourne Tram Museum
Ephemera - Badge, Australian National Philatelic Exhibition 1989 Inc, "Stampshow '89", Oct. 1989
Set of three items associated with the 1989 Stamp Show, titled "Stampshow '89" on "Australian National Philatelic Exhibition 1989 Inc" letterhead. .1 - letter welcoming the donor - A4 sheet, including receipt. .2 - Club 89 badge - metal badge with the image of a Melbourne tram - secured to a sheet of cardboard. .3 - Entrance ticket, laminated sheet with the logo and details of dates etc. See Reg Item 6655 for ticket booklet and stamps.trams, tramways, stamps, australia post -
Melbourne Tram Museum
Badge - Tie clip or tie bar, Bombardier, c2010
Tie clip or tiebar produced as a branded item by Bombardier. Bombardier Dandenong manufactured the E class trams, Velocity railcars for the Victorian Government. The Dandenong plant was sold to Alsthom when they purchased the Bombardier Rail division. The clip was given to the donor at a rail event during the early 2010s Demonstrates a tie clip produced as a branding item by Bombardier.Tiebar or tie clip - with the name Bombardier in a nickel plated finish.badges, souvenirs, tie clip, bombardier -
Melbourne Tram Museum
Uniform - Badge, Stokes and Sons, mid 1950's?
Stamped metal uniform badge for MMTB Inspectors. Tramways Board logo at top of badge in silver finish, the words "INSPECTOR" and the scroll outline in brass or gold colour. The area where the inspector's number has been painted on is in brass/gold finish. The number "5" has been painted on in royal blue colour. The enamel finish within the scroll work also finished in royal blue. On rear badge in brass/gold finish, with word "STOKES & SONS MELBOURNE" stamped into . Two metal rings have been soldered onto the rear of the badge and a spring steel clip provided to enable the badge to be clipped to a hat.\ Badge was used by the Donor as part of his work uniform. See Reg Item 6010 for another example.trams, tramways, badges, inspectors, mmtb -
Melbourne Tram Museum
Functional object - Badge, 1980's
Stamped metal badge, Metropolitan Transit badge with The Met Logo stamp into the metal with a hole at the right hand edge and key ring (12mm) and the number 140 stamped into the rear. Used as a travel pass by assigned staff. Manufacturer unknown. Badge was used by the Donor as part of his work uniform. See also Reg Item 1233 for other examples.trams, tramways, badges, officers, the met, passes -
Melbourne Tram Museum
Badge, Stokes and Sons, Travel Pass - MMTB Traffic Officer, 1963
Provided by the MMTB to its Officers, eg Inspector as a pass for free travel on its trams and for identification. See items 7082 and 577 for other examples and 7447 for the circular issuing these in Nov. 1963.Demonstrates a travel pass issued to MMTB Officers for free travel and identification to crews.Stamped metal badge, "M&MTB Traffic Officer" pass, brass 6 sided, with hole in top with green enamel around the letters and the number "135" stamped into the base. On rear has remains of "Stokes Melb". Badge was used by the Donor as part of his work uniform.trams, tramways, badges, officers, mmtb, passes -
Ballarat Tramway Museum
Badge - Union badge, Wittenbach & Co, 1930's?
... The badge belonged to the Donor's father - Bill Irvin, who...The badge belonged to the Donor's father - Bill Irvin, who ...The badge belonged to the Donor's father - Bill Irvin, who was a SEC tram driver. Bill and his elder brother Dan, both drove trams in Ballarat. The Union badge confirmed membeship of the Union and was permitted to be worn on a uniform.Has a strong association with Bill Irvin, SEC tram driver of the 1930's and demonstrates the importance of being a union member at the time and the badge provided by the unionAustralian Tramway Employees Association (Tramways Union) badge. Badge made on a steel/ silver backing with words "Australian Tramway Employees Association" on outer edge of badge with a royal blue enamel background. In centre of badge has the Australian coat of arms with a railway type spoke wheel above the logo and underneath the coat of arms the words "Federated Australia" in a banner. Has a hole in the top of the badge for a steel ring or a method of attachment to a uniform. On back of badge has stamped into the badge "BL 42", possibly indicating Ballarat and badge number. On the base of the badge has words "Wittenbach " cast into the badge. tramways, trams, unions, badges, atea, employees, bill irvin -
Melbourne Tram Museum
Badge - Uniform Lapel badge, Melbourne & Metropolitan Tramways Board (MMTB)
... in a packet that was purchased for $2.50 by the donor. Badge Uniform ...Uniform patch or lapel emblem, motif, logo, MMTB red cotton on backing for sewing onto the lapel of a uniform jacket. Shows how these were sold to the public after no longer being needed.Demonstrates the method of providing uniform emblems.Cloth badge or patch - made on black cloth backing, red stitching in red cotton forming the MMTB logo or emblem. Two loose copies and two copies in a packet that was purchased for $2.50 by the donor.tramways, conductors, badges, mmtb, clothing, uniforms, drivers, crews -
Alfred Hospital Nurses League - Nursing Archive
Book - Illustrated book, Anthe Hyslop, Sovereign Remedies: a history of Ballarat Base Hospital 1850's to 1980's, 1989
A history of Ballarat Base Hospital from the 1850's to the 1980'sHardcover is dark blue, with title, author and publisher printed in gold on spine. Dust jacket has light grey background on front and spine. Title and author in black print on front and spine. Front cover also has three photos. Back cover has white background with phot of hospital badge. Book includes 144 illustrationsA history of Ballarat Base Hospital from the 1850's to the 1980'sballarat, ballarat base hospital - history, hospitals - victoria - history