From great uncle of Miriam Armstrong who lived in the Thornbury Area.Metal kerosene hurricane lamp with lantern glass and hanger. On lid "Tropic"On lid 'Tropic', on lamp 'Chalwy' & 'Tropic'lamp, kerosens, lighting

Colour photographs of Sovereign night lights on a rainy night. sovereign hill, lighting, winter wonderland

Cut glass light shade base.lighting, electric, shade

Glass chimeny for a kerosene lamp, bulbous middle with flared top.lighting, kerosine & oil, chimney

Glass chimeny for a kerosene lamp, bulbous middle with flared top.lighting, kerosine & oil, chimney

Glass chimney for a kerosene lamp.lighting, kerosine & oil, chimney

Lamp belonged to Leigh Davies grandmotherGlass kerosene lamplighting, kerosene, oil

Francis Powell (1861-) and Francis Hanmer (1858-1925) founded Powell and Hanmer Ltd in the Summer of 1885 for the manufacturer of bike and carriage lamps. Their first advertisements began to appear in November of 1885. Early models of the automobile, motorbike and bicycles used carbide lamps as headlamps. Acetylene gas, derived from carbide, enabled early automobiles to drive safely at night. Thick concave mirrors combined with magnifying lenses projected the acetylene flame light. These type of lights were used until reliable batteries and dynamos became available, and manufacturers switched to electric lights.Acetylene bicycle light carbide. Green and red side lens. 200 cm High. Inscription Powell & Hanmer Birmingham. Previous Catalogue Number 112.lighting, accessories, bicycle light

This candle mould was used in the past to make six candles. Molten wax or tallow, together with a central thread or cotton, were poured into the columns and when set were removed from the moulds. Until the advent of electricity in the 1920s in Warrnambool, candles, lanterns and lamps were an important source of lighting in homes. Few homes had gas lighting. Many householders made their own candles from waste fat etc. This mould is retained as an example of the way householders in the past made their own candles to assist lighting in the home. This is a mould with a rectangular base and six cylindrical hollow columns with pointed ends affixed to the mould base. The columns are topped by a rectangular metal tray with the openings of the columns in the base of the tray. There is a metal clip attached to one end of the tray. The mould is very rusty warrnambool history, candles

Historically this item was before electricity lighting was available. There is no protection around the candle to prevent wind or air movement from extinguishing the candle flame therefore this means of night illumination was used within a house environment. It could be easily moved from room to room but would have insignificant "candle power" to lighten more than a few metres around it. This item was before kerosene lamps, gas lighting and electric/battery lamps This candle holder would have been used within the homes of Kiewa residences to illuminate the way from room to room where there were no other forms of lighting available. As it is relatively light in weight and with a finger/s grip it is highly portable and was in time replaced by battery powered torches. It was used in a period where home, or local made candles were a necessity of living. This Item was used before battery powered torches were invented. Although candles are still used in the late 20th and after, their fundamental use has changed and they function more as a mood enhancement item or as a back up for an electrical power failure and the alternative battery powered torch also runs out of power.1. This small basin shaped candle holder is formed of metal and sealed with a pale grey enamel skin. It has a black painted edge and finger holder. It has a raised vertical spout for the securing of the candle. The bottom of the basin is contoured from the candle base to the outer edge to allow for melted candle wax to be safely held within the basin. 2. As above. The handle is rusty but otherwise in good condition. candle-holder, portable light enamel household goods

As supply of electricity became available in the Moorabbin Shire c 1920 homes gradually changed from Gas lighting to Electrical lighting and bakelite was used for fittings. Bakelite was a safe non-conductor of the electric current. Housewives, who had ironed clothes with flat irons heated on the hearth of open fires, were delighted to be able to stand on a chair and remove the light globe and plug in their new clean and efficient electric iron. The supply of electricity to homes in the City of Moorabbin in the early 20th Century brought many welcome changes to domestic and commercial life 3 Electrical, fittings c 1931 a) a bakelite plug and socket Made in Australia b) a bakelite bayonet fitting Made in England ;c) Bakelite screw type with no markings d) A large brass and porcelain screw type with no markings L8 a) Australian Made / PIMI b) British Made in England c) No marks d) no marks electricity, electric lights, electric irons, bakelite, market gardeners, early settlers, moorabbin shire, mechanics institute cheltenham, postworld war 11 settlers, housing estates moorabbin 1950, bentleigh, ormond, moorabbin, cheltenham, clark judy, reed gladys, reed george

Kempthorne Lighting Pty. was established as Coffey Lanterns in East Malvern, Melbourne Victoria in 1931 by brothers Selwyn and Owen Coffey. They manufactured lighting fixtures and fittings including oil lamps for marine use as well as for the domestic market. In early 1936 two other brothers, Erle and Terence had joined the company which was renamed Kempthorne Lantern Works Pty., Ltd. In 1946 Kempthorne joined with a small design team who had developed a domestic fan to form the subsidiary, Mistral fans. The company previously known as Kempthorne Holding Ltd was listed on the stock exchange in 1968. In 1977-1979 Kempthorne Mistral Ltd. Was a holding company comprising of Kempthorne Lighting Pty., Ltd. & Mistral Fans Pty., Ltd. An early Australian made marine lamp by a significant manufacturer that is still in business today making electrical equipment. The item is an important artefact that was made by an early Australian business that started in the 1930s. Over the years this company has demonstrated many innovations to the manufacturer of electrical items. Marine copper Lamp, round with brass makers lozenge and rounded hollow lugs set on either side of the lamp. Heavy metal handle with brass locking pin. Lid with catch on top. Made by Kempthorne Pty Ltd Melb. 1941flagstaff hill, warrnambool, shipwrecked-coast, flagstaff-hill, flagstaff-hill-maritime-museum, maritime-museum, shipwreck-coast, flagstaff-hill-maritime-village, lamp, copper ship lamp, ship lamp, kempthorne pty ltd

Information and photographs about a bonfire and barbeque held in Briar Hill circa 1962. Frank Davis MP is lighting the bonfire with Bob Manuell looking on.This photograph and text was copied from a Facebook site. Members are people who lived in the Greensborough area and share their reminiscences of the area with others. The site is administered by a GHS member but is not officially affiliated with the Society. Any information is the opinion of the contributor. Article and photograph sourced from social media.briar hill, frank davis, bob manuell

Photograph of the first SW6 class tram built by Preston Workshops. Note the dash canopy lighting, tail lamp and the sign "This is you car Use It"Tram 850 was the first SW6 built by MMTB 1n 1939, and featured sliding doors. Some earlier class trams were retrofitted with sliding doors.MMTB SW6 Class Tram 850, possibly photographed at South Melbourne Depottramcars, tramways, sw6 class, tram 850, dash canopy lighting

Photo shows L class 103 (Route 6). Has the National Bank behind. Note the street lighting standards. Photo during the 1950sYields information about the use of the L class tram in Melbourne during the mid 1950sPhotograph - Black and White - L 103 Swanston StHas details on rear in ink and John Alfred Stamp. tramways, l class, swanston st, tram 103, trams

The Government Gazette of September 28, 1888 advertises the acceptance of a contract of 276 pounds for the purchase of a "Pillar gasalier for Library, New Law Courts". The area under the dome was obviously found to be poorly illuminated and the purchase of the pillar light was approved. A table for the library had been approved in January and these two pieces of furniture were to complement each other.The gasalier pillar is of state significance as a unique survivor of gas light illumination. It is an important part of the interior decoration of the library, contributing to its intact 19th century furnishings.The gasalier has a blackwood base, with an elaborate serpentine brass fit out for the lighting with etched glass shades. The gasalier is topped by a small figure of an emu, on the lower finials are kangaroos. While originally designed for gas the gasalier was converted to electricy in the early 20th century.

Bendigo Advertiser '' The way we were'' from 2002. Family outing: Sergeant Mac Young with his daughters Audrey, Jac and Norma atop a stone tower in 1941. This photo is believed to have been taken at Lighting Hill, in Eaglehawk. The clip is in a folder.newspaper, bendigo advertiser, the way we were

Prior to the installation of gas and electric light, pioneers used candles for lighting after sunset. This ornate candle-stick holder most likely was used in the bedroom. The family of Miss May Curtis were early settlers in Moorabbin ShireSmall white ceramic candle stick holder with pink and yellow floral transfer-printed decoration on the rim. There is also a small raised area on the rim to hold a candle-snuffer. On one side there is a small ceramic "loop" attached as a carrying handle. This item broken beyond repair by brush tailed possum when he entered Cottage via chimney 27/4/2014furnishings, lights, lamps, candles, early settlers, pioneers, moorabbin, bentleigh, ormond, brighton, kitchenware, curtis may, market gardeners

Candles were the main source of lighting during the Colonial era. The candles were made at home from tallow, or animal fat, which was readily available and inexpensive. The tallow was soft, often had an unpleasant smell, band burned with a low, quickly fading light. Beeswax candles could be bought ready-made and lasted longer when lit. Bayberry wax could also be made into candles but was the process was labour intensive and time consuming. Spermaceti was from whale oil, a growing industry in the late 1800's, made firmer candles. Around this time wooden candle moulds were invented and uniform size and shape candles could be produced using the spermaceti wax. The candle mould is significant in the evolution of household lighting. It was an asset to the 19th century homemakers, allowing the production of their own candles in a uniform size. Candlelight allowed for the extension of time available for duties.Candle mould of tinplate for one dozen (12) candles. The tubular moulds stand upright, three rows of four, in a fitted tray. Another concave tray fits over the top ends of the moulds and has a hole above each of the candles, which is used for filling the moulds with melted wax. Ends have wire-reinforced edges.flagstaff hill, warrnambool, shipwrecked coast, flagstaff hill maritime museum, maritime museum, shipwreck coast, flagstaff hill maritime village, great ocean road, candle mould, candle making, lighting, candles, tallow, beeswax, bayberry wax, spermaceti was, whale oil, candlelight

The Ballarat Junior Technical School was a division of the Ballarat School of Mines.Fourteen boys, wearing white aprons, are undertaking a practical class in turning and fitting at the Ballarat Junior Technical School. The boys work with foot pedaled and early electric lathes. The classroom has evidence of both gas and electric lighting. (the guitar shaped lamp is gas)ballarat junior technical school, ballarat school of mines, education, trade, fitting and turning

Olympic Torch relay in Stawell AreaPhoto Album red cover with black spine, Photograph of lighting the cauldron in Stawell for the 2000 Olympic torch relay 10 - Colour Photographs of various people carrying Olympic Torch in the Torch relay. 7041 Male Standing on road with Olympic Torch. People in BackgroundOn Spine Olympic Torch Relay Stawell Halls Gap 2000 Photo Album 9 on a blue sticker on a white sticker 9A

Yields information about the Ballarat Tower truck and its use to put up festoon lighting in Bridge St.Negative and Digital images of the Wal Jack Ballarat Negative file of the SEC Ballarat tower truck in the Bridge Mall, putting up festoon lighting for the an event or season. Truck outside the McDougall & Chisholm shop. Truck has the SEC logo on the door and a water bag.trams, tramways, bridge st, events, tower truck