This style of jumper has a long history in the Royal Australian Navy, descending from the uniform style of the 19th century Royal Navy.Navy blue long sleeved, heavy-weight jumper with square rig collar. On left sleeve is an embroidered patch with the word "AUSTRALIA," underneath which is an anchor insignia and three downward pointing chevrons in gold embroidery thread. On right sleeve is an embroidered patch with the word "AUSTRALIA" on the upper shoulder, underneath which is an embroidered gold wheel on a semi-circle shaped patch. The jumper has a deep neckline, tied with a cotton navy tie. Accompanying collar (0036.2) attaches to the jumper via three navy blue plastic buttons at the back of the neck, and three navy blue plastic buttons running down both left and right interior neckline. The jumper has a zip on the left hand side which runs from the hem to the waist.On patches "AUSTRALIA" Interior label at back of neck reads "ADA/2001/[broad arrow]/NSN: 8405 66 132 2508/SIZE: 111 L/NO/NAME/WOOL/POLYESTER/DRY CLEAN ONLY"royal australian navy, uniform, marine, shirt, australian defence apparel, ratings

This style of collar has a long history in the Royal Australian Navy, descending from the uniform style of the 19th century Royal Navy.Rectangular shaped collar with three white parallel lines running the border of the collar. Collar is light navy on top and striped white and blue on interior. Collar is held in place with nine buttons on the jumper, there are nine corresponding machine-stitched button holes on the collar. Handwritten on the interior at the back of the neck and on the edge of the square collar is "D. KRUEGER" On interior label on right side, "A.G.C.F./SIZE. 3/8406.66.078.0013/R.A.N./MADE IN/AUSTRALIA"royal australian navy, uniform, marine, australian defence apparel, ratings, collar

The item is a representative example of previously standard issue uniform and is in excellent condition. As a set alongside 0040.2, the uniform has aesthetic significance in its design, incorporating the Disruptive Pattern style of camouflage which has its roots in the 1980s and continues to be adapted into uniform design by the Defence Force.Field shirt in disruptive pattern colours of green, khaki and browns. Long sleeve with five buttons up the front, two chest pockets with button-down flap pockets. Both sleeves are reinforced from the elbow down to the cuff; cuffs are fastened with a single plastic button. Above the right chest pocket is a patch with embroidered inscription in black thread on disruptive pattern backing. Shirt also features plain epaulette's on both shoulders, fastened by plastic button. Manufacturer's label on interior reads "ADI P/L/VICTORIA/1989/[broad arrow]/8415.66.130.0033/SIZE. 100R/NAME/SERVICE NO./MACHINE WASHABLE/DRIP DRY ONLY/DO NOT IRON/DO NOT STARCH/DO NOT BLEACH" Patch above chest pocket reads "PARKER"camouflage, uniform, australian defence force, disruptive pattern

"A court was established in Melton by 1864, when the first recorded case was heard before Mr BA Porter JP, with Mr A Carroll as the Clerk of Courts. John James was convicted of being drunk, for which he was fined five shillings or 24 hours imprisonment. The court was held in the ‘long room’ of the old Melton Hotel, before moving to rented accommodation at the Raglan Hotel, and finally to the Roads Board office. Tenders for construction of the present building were called for by the Public Works Department on 13th February 1892. The architect Samuel Edward Brindley was born in Birmingham, England, in 1842. He was articled to the local architect, J.R. Botham, FRIBA, before emigrating to Victoria where he was employed as an architect in the Education Department from 18 August 1873. With the amalgamation of the architectural branch of the Education Department with the Public Works Department in 1884, Bindley was placed in charge of Victorian government building design for the North-Western District. In 1975, the Melton and District Historical Society became concerned at hearsay that the court house was to be demolished to make way for carparking space. Melton had been declared a ‘satellite city’ and was developing rapidly. A new shopping centre had recently been built at a setback of 60 feet (c.18 metre) from 323-329 High Street, and the court house, together with the adjacent weatherboard police station, had been left standing alone. A new police station was planned, and the weatherboard police station was subsequently demolished. In its nomination of the building for National Trust classification the Society argued that the Court House was ‘the best of two early buildings left in the main street’ (the other being a bluestone hotel) and that its loss would be ‘tragic’. However the nomination was unsuccessful, the National Trust at the time judging that it was of no particular ‘distinction’ or ‘antiquity’. The building continued to be used as a court house at least until 1991 when the Department of Housing and Construction (formerly the PWD) conducted a heritage study of court houses. By this time Federation-era architecture had achieved acceptance within the heritage movement. The building was recognised as being ‘the only surviving example in brick of the Federation Queen Anne style which was used for court houses only twice.’ Twenty years later when it was proposed to modify the eastern façade of the building to accommodate a café, the M&DHS was again concerned. This time the National Trust objected that the proposed extension would be an over-development of the site, and questioned the changes to the interior court room furnishings and fittings. The site never appears to have been nominated to the Victorian Heritage Register. It has since been converted into the Shire of Melton Tourist Information Centre". Opening of the Visitor Centre in Meltoncouncil, local architecture

BY THE time the FJ Holden was replaced with the FE in July 1956, Australia’s own had taken many steps forward. The six-volt electrics were replaced with a 12-volt set-up, the two-piece windscreen was replaced with a single curved item and the skinny 15in rims were replaced with 13x4.5 steelies. Unlike the FX-FJ, the FE was designed locally by an Australian team. The resulting car was much sleeker than the earlier models, being two inches longer in the wheelbase, four inches longer overall and slightly heavier than its predecessor. To compensate, the 132ci grey motor was blessed with another small dose of horsepower thanks to larger valves and improved cylinder heads. Other mechanical improvements included pendulum-style brake and clutch pedals, hydraulic clutch actuation, larger brake drums and recirculating ball (rather than worm and sector) steering. Other great leaps forward included optional heater, indicators, reversing lights, windscreen washers and demister. In knocked down form was the first model to be exported to New ZealandBlack painted special sedan. Added accessories include exterior sun visor, headlight protectors, and on the interior grab handle mounted across the back of the front seatDiecast special sedan badge on rear quarters. Number plate club permit 63450 Hfe special, holden, sedan, car

The FB was promoted as being longer, lower, more spacious and more powerful than the FC model, but in reality it was only slightly so on each count overerall length was 5.5 inches (140 mm) greater, although the wheelbase remained the same. The engine bore was still 3 inches (76 mm), the last model with that specification. Engine capacity was 138 cubic inches (2.16 L) but the compression ratio was raised. However, the resulting extra 4 brake horsepower (3 kW) of power did not compensate for the greater weight of the FB, so performance was inferior to that of its predecessor. Changes were also made to the brakes, front coil springs, air cleaner and clutch. Obvious styling differences were the lower bonnet, finned rear mudguards with new taillights (on the sedans and wagons only) and a wrap-around windscreen. Seating was improved, as was the instrument panel. A refinement of the FC model but appearance significantly changed with a wraparound windscreen, lower bonnet and finned rear guards.. This vehicle was purchased in NSW The interior was in excellent condition bur required extensive exterior work to bring it back to its original condition, It had a mileage of 8500. A refinement of the FC model but appearance significantly changed with a wraparound windscreen, lower bonnet and finned rear guards. It was the first Holden with acrylic paintwork.Two tone grey body , four door FB Holden sedan. Finned rear mudguard,. Holden Special Registered number 63452-Hholden, automobile, 1960, car

Their polished wood finish appears to be original to their date of manufacture during the 1960s‐70s. They were located in the head keeper’s and assistant keepers’ quarters, where their use for office purposes also may have crossed over to a domestic function. In the post‐war years the Commonwealth Lighthouse Service (CLS) introduced modern, low‐cost furnishings to lightstations. Most notably, it commissioned a number of light, compact and functional items in bulk from émigré designer, Steven Kalmar (1909‐ 1989), who played a significant role in popularising modernist design concepts in Australia and drew his ideas from Scandinavian and American design trends. Born in Hungary, he trained as an architect and his contemporary affordable furnishings were especially suitable for the open‐plan houses being built in Australia’s new post‐war suburbs. It is not known whether the bookcases bear the Kalmar label, but the design, particularly the legs and bar bracing, is a signature style that is associated with his Sydney‐based firm, Kalmar Interiors. The CLS supplied the same bookshelves to a number of other lightstations, including Point Hicks, Cape Otway and Gabo Island, as well as other types of furnishings such as tables and cabinets. The bookcases have first level contributory significance as examples of the modernist furnishings that the Sydney‐based firm, Kalmar Interiors supplied to the Commonwealth Lighthouse Service in the post‐war years.The bookcases stand at about bench level and are almost square in dimension. They have two adjustable shelves as well as the base shelf and stand on legs supported by a single stretcher with a polished wood finish.