Also postcard 7 x 10.5, similar image,Black and white photograph of the entrance, taken from lookout on Jemmys Point, shows signal light adjacent to lookout, people on slope in front of signal, New Works cottages on hummocks, ocean horizon in distance. Lakes Entrance VictoriaThe Entrance from Jemmy's Pointwaterways, dredging, ocean

Black and white photograph of the township, showing the township along Esplanade, Cunninghame Arm taken from the signal station at New Works. A very clear view of rear of Boole Poole School, later used as office, Pilot's residence and Harbour Engineer's residence, Carpenter's residence, and wooden boardwalk. Lakes Entrance Victoriawaterways, topography

Black and white small format postcard of the timber observation lookout at Jemmys Point, Lakes Entrance, Victoria, showing the updated and safer steps from ground to observation deck, with fenced landing at halfway point. Old log and seat still nearby, signal light on steel tower a short distance away.historic sites, navigation

Black and white small format postcard of the timber observation lookout at Jemmys Point, Lakes Entrance, Victoria, showing the timber tower with observation deck, signal light on steel tower nearby. Top of old standing lookout tree just visible.Jemmys Point Lakes Entrancehistoric sites, navigation, world war 1939 - 1945, room display

Also two larger copies, 11.5 x18 cm and 17 x 25.5 cm|Also an original in good order 02269.04|This is the before paired photograph used in the 150 year Lakes Entrance 1858-2008 display.|The after paired photograph number 02269.1|Also one 12 x 16 framed photograph used in room display.Black and white postcard of the timber lookout tower on Jemmys Point, Lakes Entrance, Victoria, showing the lookout between the old lookout tree, and the steel signal light tower. Below the lookout is a timber shed built during WW2 when tower was used by Kalimna Air Observors Corps. In foreground is a wooden seat replacing the old log shelter and seat.Jemmys Point Lakes Entrancenavigation, room display

This is the after paired photograph used in the 150 year Lakes entrance 1858-2008 display.|The before paired photograph number 02269|Also one 12 x 16 framed photograph used in room display.Colour photograph lookout tree and steel signal light tow on Jemmys Point. Lakes Entrance Victoria.historic sites, navigation

Black and white postcard of the timber lookout on Jemmys Point, with the signal light on steel tower nearby. Lakes Entrance Victoria,The Lookout, Lakes Entrancehistoric sites, navigation

Identical copy 10 x 15Black and white photograph copied from a postcard showing the timber lookout tower and signal light on Jemmys Point, old lookout tree in background appears to have some of the top missing. Lakes Entrance Victoria.historic sites, navigation

Also one other photograh similar showing steps, landing, and Carpenters Chev car parked.Black and white photograph of the timber lookout on Jemmys Point, steel tower with signal light in background, base of old lookout tree visible on left of image. Lakes Entrance, Victoria.historic sites, navigation

Black and white photograph of the Lookout Tree on Jemmys Point showing a standing dead grey box tree supported by two long timbers. Access to the top via a 35 foot ladder. Thelma Roder standing on top beside signal structure, two women and child standing near base. Lakes Entrance Victoria,historic sites, navigation

Colour photograph of the old lookout tree on Jemmys Point, showing a standing dead grey box tree, remains of three branches at top which once held a platform and signal structure. Two timber seats on lawn at base, roadway in foreground. Lakes Entrance, Victoria,historic sites, navigation

Colour photograph of the old lookout tree on Jemmys Point, showing a standing dead grey box tree, remains of three branches at top which once held a platform and signal structure. Two timber seats on lawn at base, roadway in foreground. Lakes Entrance, Victoria,2008historic sites, navigation

Colour photograph of the old lookout tree on Jemmys Point, showing a standing dead grey box tree, remains of three branches at top which once held a platform and signal structure. Two timber seats on lawn at base, roadway in foreground. Lakes Entrance, Victoria,historic sites, navigation

Colour photograph of the old lookout tree on Jemmys Point, showing a standing dead grey box tree, remains of three branches at top which once held a platform and signal structure. Two timber seats on lawn at base, roadway in foreground. Lakes Entrance, Victoria,historic sites, navigation

Used by Mr. Gordon Blake of Ocean Grove, retired During WWII. The flares were black gunpowder in cardboard containers. The pistol was previously in possession of Coast Watch Radio and Marine Rescue Squad Inc., Ocean GroveBlack bakelite hand grip. Steel barrel 12cm long x 5cm dia. R F Sedgley Inc. Signal Pistol Mark IV. pt 8582 1-16-43 pAT.8-22-32gordon blake, signal pistol

QUEENSCLIFFE was built in 1926 to a Royal National Lifeboat Institution (RNLI) design called the Watson Class. The double-diagonal planked vessel was built by A McFarlane and Sons in Port Adelaide SA, commissioned on the 6th of March 1926, and then officially named and launched on the 9th of April 1926. The original Wayburn petrol engine was replaced with a Gardner diesel. This gave QUEENSCLIFFE a top speed of 7.5 knots with a range of 350 miles. The equipment carried aboard included a VHF Radio Telephone, HF radio transceiver, visual signals, life rafts, hand rocket gun, flare gun, generator, search light and first aid supplies. In the tradition of many shore based lifeboats, QUEENSCLIFFE had its own shed and slipway and was always ready for launching when required to go to sea in response to an emergency call. Its area of operation included 'the Rip' at Port Phillip Heads and the Bass Strait seas immediately offshore. She was taken out of service in 1976 by the Marine Board of Victoria and subsequently offered to the Borough of Queenscliffe for care and display. The Lifeboat is listed on the Australian Register of Historic Vessels (ARHV). During her 50 years of service the Queenscliffe attended many calls for assistance both inside and outside the Heads. Some of the vessels and calls for help the lifeboat attended were: 1960 - Army Commandos lost in the Rip 1967 - The search for the late Prime Minister Harold Holt 1974 - The last attendance to a vessel was to the Brisbane Trader which was on fire The shed which housed the lifeboat is located on the Queenscliff 'New' or 'Steamer' Pier (built in 1884). This shed includes the internal section of the slipway used to launch and retrieve the lifeboat. The external slipway and some other structures associated with the lifeboat shed have been removed. Originally fitted with two masts, the stern mast being removed in the 1960's. A retractable centre plate was used when under sail. Delivered with an 80 hp Wayburn petrol motor which was later replaced by a 72 hp Gardiner diesel. Top speed of 7.5 knots and a range of 350 miles.QUEENSCLIFFE is a wooden lifeboat built in 1926 in South Australia. It has a long association with the Victorian port of Queenscliff. It was manned voluntarily by their local fishermen and is therefore closely attached to families of the Queenscliff community. It is a rare surviving example of the coastal shore-based lifeboats that were based around the Australian coastline.The lifeboat 'Queenscliffe' a Watson Class LifeboatQueenscliffelifeboat, rescue, watson class boat

This signal lamp was originally fitted on the steam tug 'Wattle'RAN Career 1932 to 1969: Wattle's construction and career as a non-commissioned vessel of the Royal Australian Navy. Saved from the Scrapyard 1969 to 1979: Sydney-based enthusiasts rescue Wattle from the scrapyard, forming an association with Sydney Heritage Fleet. Melbourne Pleasure Steamer 1979 to 2007: A volunteer group brings Wattle to Melbourne to restore, then sails Port Phillip on outings and excursions. Restoration Journey 2007 to 2015: Wattle is hoisted onto the hard to undergo major restoration work. Back in the Water, 2015 to present: Wattle returns to the water for further restoration, and in 2019 sails again on Port Phillip.Brass candle powered signal lamp with a lens circumference of 14cm, mounted on a timber plinthSundercombes Patent Eclipsesignal light, marine fittings, steam tug 'wattle'

Doris Lilian Wright of 214 Union Road was a milliner but joined the Australian Women's Army Service (AWAS) in the early war years. The Women’s Australian National Service (WANS) was inaugurated in 1940. Training for members of the WANS included air raid drills, first aid, basic military drills, and even shooting, signalling, and mechanics. AWAS on formed on 13 August 1941 with the objective of releasing more men into forward areas. The Army was particular with its recruiting and four references were required; another stipulation was that teeth were in good condition. Doris was located at Elwood. Their training area was along the foreshore and one day to their great surprise there were crowds of American Marines – "the cream of the American Army". These were the first Americans to arrive in Australia to strengthen the defence of the country. The Americans soon went north and the AWAS went off to Balcombe on the Mornington Peninsula. At this time there were no uniforms for the girls only ‘giggle’ dresses – of a non-descript colour. They were not expected to appear in public in these and wore civilian dress. Japan had just entered the war and there were more urgent demands on restricted supplies. The formal uniforms eventually arrived.A black and white photograph of a lady in an army uniform and wearing a hat.union road, surrey hills, uniforms, clothing and dress, (miss) doris wright, australian women's army service

Further information on the unidentified object has not been available during preparation of this report, but it may be a buoy light, or perhaps even a solar powered rotating light made by Pharos Marine, New Zealand. Portable beacon lights were made with a plastic lens and an aluminium base and it is known that one of these was installed in the Gabo Island Lighthouse in February 1992. It was replaced in May 2006 and the lights are now no longer used within the AMSA network. The unidentified item, which can be described as a white painted conical object, appears to be associated with signalling, but more information is needed to confirm this. These items of equipment are presumed to relate to core lightstation functions and look to be in good condition. They have at least second level significance for their probable provenance and association with the theme of visual signalling and the use of navigation equipment for maintaining safe routes for shipping.Beacon and unidentified object (GILS 0095) The portable beacon is a small rotating light containing a lens and prism. The other item can be described as a white painted conical object.

A marine foghorn gives an audible navigational signal to warn vessels of dangers, hazards and the presence of other vessels in fog conditions. The foghorn signal is a series of long and short sounds with short or long pauses between them. These common signals conform to a code called the International Regulations for Preventing Collisions at Sea and provide such information as whether the vessel is under sail or motor, large or small, aground or at anchor. The designs of foghorns vary but they all use a column of air to make a loud sound. Some use vibrating plates or metal reeds, others force air through holes in a revolving cylinder or disc, sounding like a siren, and some use a clockwork mechanism to open the valves that let the air into the horn. They are usually built to meet particular specifications e.g. U.S.C.G. (US Coast Guard). This Tyfon plunger foghorn has a horizontal handle attached to a vertical rod that moves up and down inside a cylinder. When the handle is plunged down, in a similar way to a bicycle pump, the air is forced out of the bottom of the cylinder into a pipe with a bell-shaped horn on the end, making a loud, low sound. The wider base of the cylinder helps to keep it stable. The original type Tyfon foghorns were manufactured in about 1910 by Kochums Mechanical Workshop (Kockums Mechanical Werkstad, Ltd.), Malmo, Sweden. The company was established in 1840, became a Limited company in 1866, and established a shipyard at the Port of Malmo, Sweden, in 1870. The civilian ship production in Malmo ceased in 1987. As well as building ships the company built large industrial and agricultural machinery and maritime goods.this replica foghorn represents the design of a Swedish, Tyfon model 1910. It is an example of the type of safety equipment used on marine vessels to signal other vessels and signal to land. Replica foghorn; portable marine, plunger operation. It has a brass cylinder and adjustable brass horn. The plunger handle and base are wooden. Inscriptions are on the plaque on the horn and moulded into the air intake. Facsimile of a Kockums of Malmo, Sweden, Tyfon model 1910 Fog Horn.Impressed into the attached plaque "KOCKUMS MLK. VERKSTAD / MALMO SWEDEN" and "TRADE TYFON MARK" Also added to the plaque individually "288938" Molded around the circumference of the air intake "TYFON PATENT"flagstaff hill, warrnambool, shipwrecked coast, flagstaff hill maritime museum, maritime museum, shipwreck coast, flagstaff hill maritime village, great ocean road, foghorn, fog horn, tyfon foghorn, kockums mlk verkstad, malmo sweden, replica, warning signal, safety equipment, ship's equipment