Showing 94 items
matching engineer drawings
-
Melbourne Tram Museum
Document - Report, Victorian Parliament, "Report of the Street Works Co-ordination Committee", 1966
Report - titled "Report of the Street Works Co-ordination Committee", includes a table of contents and drawings of street cross-sections. Details the committee members, meetings, terms of reference, suggested legislation, summary of conclusions and recommendations, including previous reports and conference and typical cross sections. Dated 1966, for presentation to the then premier Mr Hamer. Looks at the co-ordination road works by authorities including the tramways.Yields information about an investigation into co-ordination of tram track and other road works.Report - approx 50 pages - side stapled, card covers, cloth side binding."KCP Designing Engineer attended some later meetings"tramways, mmtb, tram tracks, parliament, road works -
Melbourne Tram Museum
Book, Melbourne & Metropolitan Tramways Board (MMTB), "MMTB Electric Tramways and Motor Omnibuses Sections and Fares", 1976
Grey cardboard with light grey cloth end binding covered book, 124 pages "MMTB Electric Tramways and Motor Omnibuses Sections and Fares", dated July 1976. Inside the book - see image 80i4, was a heavy sheet of cardboard headed "Fares Charges from 4/7/76" giving the adult and child fares for each section of travel. Details the various section stages and fares for each tram and bus route, General instructions, concession fares and has photos or drawings of the various special tickets, eg passes or prepaid tickets. Book consists of eight sections, bound with cloth binding on the outside covering internal staples. Second copy added 27-12-2013 ex AETA. (This copy removed and replaced with a better condition one 15-1-2015 - Ex Lindsay Rickard) Third copy added 14-12-2015 from donation of Norm Cross 11-10-2009.Copy three - has "Executive Engineer 30-8-76" written on the inside of the front cover and "As at 4-7-76" on page 1 in ink.trams, tramways, tickets, fares, sections, passes -
Melbourne Tram Museum
drawing - Folder with papers, Melbourne & Metropolitan Tramways Board (MMTB), "PCM Tram Equipment", 1970's?
Foolscap Manila Folder titled "PCM Tram Equipment" with the following papers secured with an Arnos binder. Many of the documents seem to have been copied onto heat sensitive paper. Have tissue paper separating them. 1. Wiring Diagram - GE PCM Control Equipment - R4284B. 2. Westinghouse - Load test on Repair Railway Motors 3. Letter to Chief Engineer MMTB from Australian General Electric - 23/7/1935 - re delivery of 15 cases of PCM Equipment by ship and attaching drawings. 4. Drawings and maintenance notes for above - includes field shunts, magnet valves, cases, 5. GE Specification Ry-5313 - General Electric PCM Control for 4-40HP 600Volt Motors with Shunted FieldsOn rear cover in ink "To Norm Cross"trams, tramways, electro pneumatic, pcm, controllers, general electric, mmtb, tramcars -
Melbourne Tram Museum
Drawing - Digtial image, Melbourne & Metropolitan Tramways Board (MMTB), "Plan and Longitudinal sections of Howard Street Siding", 2/1925
Digital image of a drawing for the access tracks to the Howard St car house or cable tram depot from Victoria St. Shows the plan and longitudinal sections. Prepared 23/2/1925 and signed by Mr Strickland Chief Engineer on 25/2/1925. This depot was made necessary by the construction of electric tram tracks in Flemington Road in 1925 which resulted in the closure of the Flemington Road car house near Racecourse Road North Melbourne.Yields information about the access track from Victoria St to the Howard St car house. Digital image of drawing P1613, "Plan and Longitudinal sections of Howard Street Siding".m&mtb, drawings, howard st, cable trams, car houses, depots