K Class 157 Steam Train Engine pulling freight in cutting under Colquhuon Street bridge. Photo was taken from Hill Street Stawell around c 1962. Copy from original photograph of "K" Class 157 Steam engine pulling freight trucks going up the cutting and under the Colquhuon St. bridge. The rail line runs parallel to Napier St. c 1962. K 157.railways

A poster promoting the merits of travelling by train to the Royal Melbourne Show of 1958. The Showgrounds train station was one of the first buildings built on the Melbourne Showgrounds in Ascot Vale when the site was established in 1883, allowing patrons quick access to the venue despite it being slightly further out from the city than previous sites.A portrait poster, printed in colour; in the upper half of the poster there is an illustration showing a family of four, walking to the right; in the background is a photograph of a train station; the lower half of the poster consists of a list of the advantages of taking the train, printed on five horizontal stripes, white and green; colour process lithograph, linen-backed.BY TRAIN of course / TO MELBOURNE'S / ROYAL SHOW / SEPTEMBER 18 - 28, 1958/ NO PARKIGN PROBLEMS OR FEES / FREQUENT EXPRES SERVICE FROM FLINDERS ST. & SPENCER ST. RIGHT TO THE GROUNDS / DAY OR PERIODICAL TICKETS; COMBINED RAIL-ADMISSION TICKETS / NEW RAILWAY EXHBIIT WITH FREIGHT ADVISORY SERVICE / YOUR SUBURBAN STATION AHS DETAIL-PACKED PAHMPHLET /train, metro trains, showgrounds, melbourne showgrounds, royal melbourne show, 1985 melbourne royal show, melbourne royal show, showgrounds station, railway

This photograph shows members of the Light Horse passing a wrecked train at Ramleh [Egypt]Digital copy of black and white photograph. "Wrecked train Ramleigh"charles marshall, world war 1

The Davey Paxman Experimental Steam Engine was purchased as the result of a bequest from Thomas Bath. The 'substantial sum' was used to build an Engineering Laboratory. The Ballarat School of Mines Council minutes of 08 November 1901 record: - Plans for [the] proposed building were submitted ... and ... it was resolved that a temporary building for an Engineering Laboratory be put up.' This laboratory, as an existing building, is first mentioned in the Ballarat School of Mines President's Annual Report of 1901, presented on 28 February 1902, reporting 'the erection of a building 67ft long by 33 ft wide' This report also lists all the equipment that would be accommodated in the Engineering Laboratory, including the experimental steam engine and boiler. The experimental Davey-Paxman steam engine arrived in Ballarat towards the end of 1902. The Engineering Laboratory was opened on 14 August 1903 by His Excellency Sir Sydenham Clarke. This engineering laboratory remained in use till about 1945. By 1944 preparations were under way at the Ballarat School of Mines to expand existing facilities, to be ready for the influx of returned soldiers. A new Heat Engines laboratory was built, this time of brick construction, replacing the previous corrugated-iron shed. In the early stages the steam engine was used to drive an overhead transmission shaft for machinery in the adjacent workshop. Later the steam engine was moved to a space that became the Heat Thermodynamics Laboratory. At the end of 1969 the engine was relocated to the Thermodynamics Laboratory at the then Ballarat Institute of Advanced Education (BIAE) Mt Helen Campus. It was donated to Sovereign Hill in 2006. According to the research of Rohan Lamb in 2001 around five experimental steam engines were made by Davey Paxman, and three of these had similar configuration to the Ballarat School of Mines Steam Engine, however, each of these was also unique with different valve arrangements. The list, which was on a scrap of paper in a folio held in the Essex Archives, confirmed that one was sent to India. The Ballarat steam engine can be dated to late 1901 to early 1902. Zig Plavina was responsible for moving the steam engine to Mount Helen, and worked on it as a technician for many years. He observed the following: * The condenser is driven by the low pressure engine. * The following arrangements are possible: i) the high pressure engine alone, exhausting to atmosphere. Condenser not used, crankshaft flanges not coupled. ii) crankshafts coupled, mains pressure (120 psi) steam supplied to high pressure engine, partially expanded steam delivered to low pressure engine (Tandem operation). Choice available re exhaust steam: either to the condenser or to atmosphere. iii) crankshafts not coupled, reduced pressure steam supplied to low pressure engine. Exhaust steam - either to the condenser or to atmosphere. * Valve arrangement - a choice of Pickering cut-off or throttle governor. On low pressure engine - throttle governor only. Black and white photograph of an experimental steam engine which was produced for the Ballarat School of Mines. It was designed for experimental purposes, such as testing of efficiency, etc. The laboratory which housed the steam engine was lit with gas lighting. davey paxman experimental steam engine, model steam engine, davey paxman, steam, thomas bath, thermodynamics

Train Sand Bucket The Train Sand Bucket was usually carried in the guards van of a train and was used to sand the rails when required to provide traction for the locomotive to haul its load up steep grades.Historic - Railways - Train Sand BucketTrain Sand Bucket made of metal puffing billy, train sand bucket

Built by Aveling & Porter Ltd., Rochester, Kent, England Builder’s Number 11629 of 1923 Weight 10 Tons Used by the South Melbourne Council in road construction between 1926 and 1963 Aveling and Porter was a British agricultural engine and steam roller manufacturer. Thomas Aveling and Richard Thomas Porter entered into partnership in 1862, developed a steam engine three years later in 1865. The company became the largest manufacturer of steam rollers in the world. Service History : Title: City Surveyor's report Creator: Johnson, A.L Publisher: Prahran City Council Date: 1921 .... The 10-ton steam roller worked 302 days, the Aveling and Porter 12½-ton roller worked 211 days while the Garrett steam wagon continues to carry tar and road materials. city of prahran annual reports 1912-1913 http://www.stonnington.vic.gov.au/files/assets/public/history/city-of-prahran-annual-reports-1912-1913.pdf Industrial Steam Roller - Road Construction, South Melbourne, Victoria, Australia Aveling & Porter 10 ton Steam Roller with roof and rear tool box Builders Number 11629 Aveling & Portersouth melbourne, puffing billy, steam roller, aveling and porter, puffing billy museum, road construction, road steam

This poster promotes the merits of travelling by train to the Royal Melbourne Show of 1958. The Showgrounds train station was one of the first buildings built on the Melbourne Showgrounds in Ascot Vale when the site was established in 1883, allowing patrons quick access to the venue despite it being slightly further out from the city than previous sites.A poster, printed portrait and in colour. The upper half of the poster shows a woman on a jumping horse, on a purple background; the lower half consists of a list of the advantages of taking the train, lettered in white on a black background; screenprint and process lithograph, linen-backed.SEPT. 19 – 28 / Go to / MELBOURNE'S / ROYAL SHOW / by train / - RIGHT TO THE GROUNDS / - NO PARKING PROBLEMS / - COMBINED RAIL-ADMISSION TICKETS / - WEEKLY OR NINE DAY RAIL TICKETS / - SEE THE RAILWAYS EXHIBIT / - MEMBERSHIP TICKETS AT VICTORIAN / GOVT. TOURIST BUREAU /train, metro trains, showgrounds, melbourne showgrounds, royal melbourne show, 1958 melbourne royal show, melbourne royal show, showgrounds station, railway

Date is approximate. Electric trains replaced steam locomotives in 1922. Mr William Holmes of 'Lugano', Mont Albert Road was in charge of the design and introduction of the electrification of the Melbourne rail system.Black and white photo of an early electric train approaching the platform at Mont Albert station. A couple of spindly eucalyptus trees can be seen beyond the picket fence marking the boundary of the platform.Black and white photo mounted on card; measures 16.3 cm x 23.4 cm.mont albert station, railways, trains, norman carter

The Davey Paxman Experimental Steam Engine was purchased as the result of a bequest from Thomas Bath. The 'substantial sum' was used to build an Engineering Laboratory. The Ballarat School of Mines Council minutes of 08 November 1901 record: - Plans for [the] proposed building were submitted ... and ... it was resolved that a temporary building for an Engineering Laboratory be put up.' This laboratory, as an existing building, is first mentioned in the Ballarat School of Mines President's Annual Report of 1901, presented on 28 February 1902, reporting 'the erection of a building 67ft long by 33 ft wide' This report also lists all the equipment that would be accommodated in the Engineering Laboratory, including the experimental steam engine and boiler. The experimental Davey-Paxman steam engine arrived in Ballarat towards the end of 1902. The Engineering Laboratory was opened on 14 August 1903 by His Excellency Sir Sydenham Clarke. This engineering laboratory remained in use till about 1945. By 1944 preparations were under way at the Ballarat School of Mines to expand existing facilities, to be ready for the influx of returned soldiers. A new Heat Engines laboratory was built, this time of brick construction, replacing the previous corrugated-iron shed. In the early stages the steam engine was used to drive an overhead transmission shaft for machinery in the adjacent workshop. Later the steam engine was moved to a space that became the Heat Thermodynamics Laboratory. At the end of 1969 the engine was relocated to the Thermodynamics Laboratory at the then Ballarat Institute of Advanced Education (BIAE) Mt Helen Campus. It was donated to Sovereign Hill in 2006. According to the research of Rohan Lamb in 2001 around five experimental steam engines were made by Davey Paxman, and three of these had similar configuration to the Ballarat School of Mines Steam Engine, however, each of these was also unique with different valve arrangements. The list, which was on a scrap of paper in a folio held in the Essex Archives, confirmed that one was sent to India. The Ballarat steam engine can be dated to late 1901 to early 1902. Zig Plavina was responsible for moving the steam engine to Mount Helen, and worked on it as a technician for many years. He observed the following: * The condenser is driven by the low pressure engine. * The following arrangements are possible: i) the high pressure engine alone, exhausting to atmosphere. Condenser not used, crankshaft flanges not coupled. ii) crankshafts coupled, mains pressure (120 psi) steam supplied to high pressure engine, partially expanded steam delivered to low pressure engine (Tandem operation). Choice available re exhaust steam: either to the condenser or to atmosphere. iii) crankshafts not coupled, reduced pressure steam supplied to low pressure engine. Exhaust steam - either to the condenser or to atmosphere. * Valve arrangement - a choice of Pickering cut-off or throttle governor. On low pressure engine - throttle governor only.Black and white photograph of the Davey Paxman Experimental Steam Engine installed at the Ballarat School of MInes. steam engine, model steam engine, davey paxman, thomas bath, experimental steam engine

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

Colour photograph of railway power lines and signals. melbourne, train, flinders street, spencer street, northbank, buildings, cbd, tranmission lines, power lines, railway

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, flinders street, spencer street, northbank, buildings, cbd

melbourne, train, richmond, punt road, oval, tigers

melbourne, train, richmond, punt road, oval, tigers

melbourne, train, richmond, punt road, oval, tigers

melbourne, train, richmond, punt road, oval, tigers

Black and white photograph of Signal Box No1 and train in Stawell. Railway signal box and train stawell

Printed on blue paper; one corner torn offArrival time at Eltham updated from 1.15pm to 12.40 in blue ink1992, diana and peter bassett-smith collection, eltham festival, steam train

Digital TIFF file Scan of 35mm Ilford FP3 black and white negative transparencyechuca-moama road rail bridge, george coop collection, goods train, k-158, k-class steam locomotive (vr newport workshops)

Looking south towards Echuca, Victoria Image dated as November 1963 based on same image in Port of Echuca collection (print 19.5 x 24.5cm) On reverse in blue pen:" Photo by: George L. Coop Nov 1963". In red pen top left hand corner"Ch 11, (circled number )1. In pencil circled: "35". In pencil : " J Class. Intro Scotland 1948 early 50s." https://victoriancollections.net.au/items/59deb0d421ea6e12dc488c2fDigital TIFF file Scan of 35mm Ilford FP3 black and white negative transparencyechuca-moama road rail bridge, george coop collection, goods train, j-500, j-class steam locomotive (vulcan foundry)

Looking south into Echuca, VictoriaDigital TIFF file Scan of 35mm Ilford FP3 black and white negative transparencyd3-639, d3-class steam locomotive, echuca-moama road rail bridge, george coop collection, murray river, vr commissioner's special train

Digital TIFF file Scan of 35mm Ilford FP3 black and white negative transparencyd3-639, d3-class steam locomotive, echuca railway station, george coop collection, vr commissioner's special train