Historical information

The FB was promoted as being longer, lower, more spacious and more powerful than the FC model, but in reality it was only slightly so on each count overerall length was 5.5 inches (140 mm) greater, although the wheelbase remained the same. The engine bore was still 3 inches (76 mm), the last model with that specification. Engine capacity was 138 cubic inches (2.16 L) but the compression ratio was raised. However, the resulting extra 4 brake horsepower (3 kW) of power did not compensate for the greater weight of the FB, so performance was inferior to that of its predecessor. Changes were also made to the brakes, front coil springs, air cleaner and clutch.
Obvious styling differences were the lower bonnet, finned rear mudguards with new taillights (on the sedans and wagons only) and a wrap-around windscreen. Seating was improved, as was the instrument panel. A refinement of the FC model but appearance significantly changed with a wraparound windscreen, lower bonnet and finned rear guards..

Significance

This vehicle was purchased in NSW The interior was in excellent condition bur required extensive exterior work to bring it back to its original condition, It had a mileage of 8500. A refinement of the FC model but appearance significantly changed with a wraparound windscreen, lower bonnet and finned rear guards. It was the first Holden with acrylic paintwork.

Physical description

Two tone grey body , four door FB Holden sedan. Finned rear mudguard,.

Inscriptions & markings

Holden Special Registered number 63452-H

Subjects