Sign - engraved brass sheet, with black lettering and lining on the outside and screw holes in each corner with the words. "NOTICE TO TRAM CREWS / If you are involved in any incident that may cause a DELAY TO THE SERVICE / RING CONTROL ROOM IMMEDIATELY" The sign provides the track telephone number to call and public phone number and that cost of calls would be refunded. Four copies heldtrams, tramways, signs, tramcars, tramways, crews, mmtb

Australian Tramway Employees Association (Tramways Union) badge. Badge made of brass with words "Australian Tramway Employees Association" on outer edge of badge with a royal blue enamel background. In centre of badge has the Australian coat of arms with a railway type spoke wheel above the logo and underneath the coat of arms the words "Federated Australia" in a banner. The metal ring at the top of the badge has been torn. On back of badge has stamped into the badge "1580", indicating badge number. No indication of manufacturer.trams, tramways, unions, badges, atea, employees

Set of four nickel silver MMTB Coat buttons with brass backs and a sewing lug or ring on the rear. All of the items are made by Buttons of Birmingham - name stamped into the rear section. Two large - 22mm diameter and two 15mm dia. Received in a small envelope with information that they were issued by the Interim Tramway Board. The design appears to be similar or identical to that of the MMTBIn a small manila envelope "2 large and 2 small buttons issued by the (interim) Tramways Board on their uniforms of its cable tram crews"trams, tramways, melbourne tramways, uniforms, buttons, tramway board, cable trams

Bell used by the conductor to signal to the driver to stop, proceed or an emergency stop. The flat leather strap indicates it was used on a cable tram, rather than an electric tramcar which were fitted with round leather cords. The leather strap is riveted to a round steel ring.Demonstrates a conductors communication or signal bell made for use on cable trams.Brass Conductor Communication Bell, or signal bell, consisting of cast frame, bell striker and bell pull part. Has at both ends, four open screw holes that were used to secure the bell to the roof of a tram with a flat 22mm wide leather strap attached using a steel ring.trams, tramways, conductors, bells, cable trams

Stamped metal uniform badge for MMTB Depot starters. Tramways Board logo at top of badge in silver finish, the words "DEPOT STARTER" and the scroll outline in brass or gold colour. The enamel finish within the scroll work also finished in royal blue. On rear badge in brass/gold finish, with word "RG LUKE MELB" stamped into . Two metal rings were soldiered onto the rear of the badge, but have been removed.trams, tramways, badges, depot starter, mmtb

Stamped metal uniform badge for MMTB Inspectors. Tramways Board logo at top of badge in gold finish, the words "INSPECTOR" and the scroll outline in brass or gold colour. The area where the inspector's number has been painted on is in brass/gold finish. The number "91" has been painted on in royal blue colour. The enamel finish within the scroll work also finished in royal blue. On rear badge in brass/gold finish, with word "STOKES & SONS MELBOURNE" stamped into . Two metal rings have been soldered onto the rear of the badge and a spring steel clip provided to enable the badge to be clipped to a hat.\ See Reg Item 395 for another example.trams, tramways, badges, inspectors, mmtb

Issued by the Prahran and Malvern Tramways Trust to its Officers to enable free travel on its tramcars. See item 1659 for another example of a Sterling Silver pass and 399 and 576 for examples of a similar passlDemonstrates a travel pass issued to PMTT Officers.Set of two cast hexagonal nickel plated brass or sterling silver badges with a single hole in the top, with words "Prahran Tramways Trust Malvern" on one side and on reverse"Officers No. Pass" with the number "17" or "78" stamped in. One fitted with a nickel-plated ring. Raised edges with flat sides. Manufacturer unknown. On the lower edge of the reverse of badge 17 are the letters "STC.SN" stamped in, indicating a Sterling Silver item.tramways, trams, badges, tickets, travel pass, pmtt, officers, passes

Provided by the Prahran and Malvern Tramways Trust to its employees as a pass for free travel on its trams. See item 466 for other examples.Demonstrates a travel pass issued to PMTT Employees for free travel.Cast triangular brass badge with a single hole in the top, with words "Prahran Tramways Trust Malvern" and "Employees Pass" on one side and on reverse"the number "47" stamped in and the letter "O" engraved. Raised edges with flat sides. Manufacturer unknown. Fitted with a steel lug or ring at the top of the item. tramways, trams, badges, tickets, travel pass, pmtt, employees, passes

Provided by the MMTB to its Officers, eg Inspector as a pass for free travel on its trams. See items 397 and 577 for other examples and 7447 for the circular issuing these in Nov. 1963.Demonstrates a travel pass issued to MMTB Officers for free travel and identification to crews.Stamped metal badge, "M&MTB Traffic Officer" pass, brass 6 sided, with hole in top with green enamel around the letters and the number "1" or "4" stamped into the base. On rear has the manufacturer's "Stokes Melb" stamped in. Badge 1 has a fitted ring clip installed. See items 397 and 577 for other examples and 7447 for the circular issuing these in Nov. 1963. tramways, trams, badges, tickets, travel pass, employees, passes, mmtb, traffic officers

Stamped metal uniform badge for MMTB Inspectors. Tramways Board logo at top of badge in silver finish, the words "INSPECTOR" and the scroll outline in brass or gold colour. The area where the inspector's number has been painted on is in brass/gold finish. The number "5" has been painted on in royal blue colour. The enamel finish within the scroll work also finished in royal blue. On rear badge in brass/gold finish, with word "STOKES & SONS MELBOURNE" stamped into . Two metal rings have been soldered onto the rear of the badge and a spring steel clip provided to enable the badge to be clipped to a hat.\ Badge was used by the Donor as part of his work uniform. See Reg Item 6010 for another example.trams, tramways, badges, inspectors, mmtb

Set of 27 Stamped enamelled round brass pieces with a hole stamped at the top and ring placed through. Used as a SEC tramways employees pass for either all Provincial tramways, Ballarat or Bendigo only. All badges have the SEC logo in the centre, organisational name (State Electricity Commission of Victoria) in white enamel and outer ring the words "Electricity Supply Department, Provincial Tramways", or "Electric Tramways Ballarat" or "Electric Tramways Bendigo". This is in blue enamel. On the rear are stamped numbers and manufacturers name - "AMOR" or "AMOR MELB" or "STOKES & SONS MELBOURNE" in the bottom portion of the pass. Items .1 -> .10, .12, .13 individually tagged. Item .11 not tagged Item .13 -> .27, single tagged, tied together with a length of string. 1941.1 - Bendigo - No. 9 - Stokes - silver background instead of gold, appears to have been used. .2 - Bendigo - No. 43 - Stokes - has been used - partially worn, has additional clip joined to main ring. .3 - Ballarat - No. 51 - Stokes - has been used, worn and chipped under main ring. .4 - Ballarat - No. 61 - Stokes - has been used, worn, and chipped on blue enamel in at least two places. .5 - Ballarat - No. 72 - Stokes - has been used, worn and chipped on blue enamel in many places - btm1941i1 for reverse side. .6 - Ballarat - No. 86 - Stokes - has been used, worn, dirt on rear - see image btm1941i2 for front side. .7 - Bendigo - No. 107 - Stokes - appears not to have been used - see image btm1941i3 for front side .8 - Bendigo - No. 108 - Stokes - ditto, but gold by SEC shield is discoloured - see image btm1941i4. .9 - Bendigo - No. 121 - Stokes - appears to have been used, more silver than 1941.8 .10 - Provincial - No. 124 - AMOR - may have been used - see image 1941i5 for front side .11 - Provincial - No. 156 - AMOR - small clip broken off at top, has been used, worn (Not tagged) .12 - Provincial - No. 306 - AMOR - no larger ring, has been used, worn and discoloured .13 - Provincial - No. 656 - AMOR MELB - has not been used, no larger ring, see image 1941i6 for back side. .14 - Provincial - No. 642 - AMOR MELB - has not been used. .15 - Provincial - No. 644 - ditto .16 - Provincial - No. 645 - ditto .17 - Provincial - No. 646 - ditto .18 - Provincial - No. 647 - ditto .19 - Provincial - No. 648 - ditto .20 - Provincial - No. 649 - ditto .21 - Provincial - No. 650 - ditto .22 - Provincial - No. 651 - ditto .23 - Provincial - No. 652 - ditto .24 - Provincial - No. 653 - ditto .25 - Provincial - No. 654 - ditto - to A. Reither for 21st from BTM 2/8/03 - see attached image btm1941i7 .26 - Provincial - No. 655 - ditto - to P.Mong for 21st from BTM 2/8/03 - see ditto .27 - Provincial - No. 564 - ditto - added 21/1/2007 from somewhere - at WAD's house 12/2006. .28 - Provincial - No. 589 - ditto - dittotramways, trams, employees pass, tickets, provincial tramways, badges

Demonstrates how the SEC used signage to confirm procedures for Tramway Crews. A metal, brass coloured sign originally etched and painted with black for the lettering and border lines. The sign has been overpainted with green paint. The sign gives detailed instructions to Tram Crews who may be involved in an incident which delays the service. The plate has a hole in each corner to enable attachment to the tram cab. The reverse has some black paint splotches from the painting of the lettering.tramways signs, etched tramway signage

Used in orchards by Harry Shaw (Orchardist in Springvale Rd, Glen Waverley near cnr Highbury Road) Orchard was sold in 1950. Later used on poultry farm in Forest Hills.Body of scales: brass plate inscribed - Salter Pocket Balance, made in England. No.3. To weigh 50LB. Slide measure 0 to 50. Pattern at top: twisted rope with arrow through middle. Reverse side: green painted metal. Hanging metal ring at top end and metal hook at lower end. Salter Pocket Balance, Made in England. No.3. To weigh 50LB.

The stove was the property of John Biggart, who lived in Avonsleigh. He travelled Victoria from 1920 to the 1940's. The stove was used at a work camp site.Brass base containing the kerosene fuel tank, above which rises a burning tube and burner assembly. The steel top rings are held above the burner by 3 support legs. To light the stove, a small amount of alcohol is put into the spirit cup, just below the burner to preheat it. Kerosene was then vaporised, mixed with air and it burns with a soot less, blue flame.PRIMUS No. 1. MADE IN SWEDEN. TRADEMARK PRI-MUS. PATENT SB. No 48624. ENG No 171536, all on the top of the tank. On the side is engraved; A/B B. AHJORTH AND CO. STOCKHOLM SWEDEN - SOLEMAKERS OF THE GENUINE

Cuff link owned and worn by Colin Kerr.Small, rectangular, brass cuff link with leaf pattern, inscribed with initials "GLS", two links of a chain attached to a ring at the back.colin kerr, cuff links, jewellery